Rear Stabilizer Bar

SUSPENSION: REAR STABILIZER BAR: INSPECTION

1. INSPECT REAR STABILIZER LINK ASSEMBLY

(a) Inspect the turning of the ball joint.





(1) Secure the rear stabilizer link assembly in a vise using aluminum plates.

(2) Install the nut to the rear stabilizer link assembly stud.

(3) Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

Turning torque:

0.05 to 0.98 N*m (0.5 to 10 kgf*cm, 0.4 to 8.7 in.*lbf)

HINT
If the turning torque is not within the specified range, replace the rear stabilizer link assembly with a new one.

(b) Inspect the dust cover.

(1) Check that the dust cover is not cracked and that there is no grease on it.

HINT
If there is any abnormality, replace the rear stabilizer link assembly with a new one.