Installation (from 12/2010)

SUPPLEMENTAL RESTRAINT SYSTEM: DRIVER SIDE KNEE AIRBAG ASSEMBLY: INSTALLATION

1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

(a) Connect the connector to the driver side knee airbag assembly.





NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Install the driver side knee airbag assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

2. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER LH

3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH

4. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

5. INSTALL FRONT DOOR SCUFF PLATE LH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

7. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

HINT
Some systems need initialization when disconnecting the cable from the negative battery terminal.

8. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light Diagnosis System (from 12/2010).