Door Lock Position Circuit

LIGHTING: LIGHTING SYSTEM: Door LOCK Position Circuit
- Door LOCK Position Circuit

DESCRIPTION

This circuit detects the state of the door lock detection sensor and sends it to the body ECU.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Body / Active Test.

(e) Read the display on the Techstream.

Body (Body ECU)





OK:

Normal conditions listed above are displayed.

NG -- INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

2. INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.





Standard voltage:





NG -- GO TO POWER DOOR LOCK CONTROL SYSTEM

OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE