Operation Check

MIRROR: POWER MIRROR CONTROL SYSTEM (w/ Memory): OPERATION CHECK

1. CHECK REMOTE CONTROL MIRROR FUNCTION

(a) Turn the ignition switch to ON.

(b) With the mirror select switch set to L, check that the mirror surface moves up, down, left and right normally.

(c) With the mirror select switch set to R, check that the mirror surface moves up, down, left and right normally.

2. CHECK MEMORY CALL FUNCTION





HINT
The SET, M1 and M2 seat memory switches are shown in the illustration.

(a) Turn the ignition switch to ON and the shift lever is in the P position.

Text in Illustration





(b) Check the M1 switch.





(1) Using the mirror adjust switch, turn the mirror surface to the full left position.

Text in Illustration





(2) Check that the buzzer sounds for 0.5 seconds and the mirror position is memorized when the M1 switch is pressed within 3 seconds of the SET switch is being pressed.

NOTICE:
* The mirror surface position will be stored when the M1 switch is pressed after first pressing and holding the SET switch.
* The mirror surface position will not be stored when the SET switch and M1 switch are pressed simultaneously.
* The mirror surface position will not be stored when 2 of the memory switches are pressed simultaneously (for example, M1 and M2) after first pressing the SET switch.

(3) Using the outer mirror switch assembly, turn the mirror surface to the full right position.

(4) Press the M1 switch.

(5) Check that the buzzer sounds for 0.1 seconds and the outer mirror automatically moves to the recorded full left position.

(c) Check the M2 switch.





(1) Using the mirror adjust switch assembly, turn the mirror surface to the full right position.

Text in Illustration





(2) Check that the buzzer sounds for 0.5 seconds and the mirror position is memorized when the M2 switch is pressed within 3 seconds of the SET switch being pressed.

NOTICE:
* The mirror surface position will be stored when the M2 switch is pressed after first pressing and holding the SET switch.
* The mirror surface position will not be stored when the SET switch and M2 switch are pressed simultaneously.
* The mirror surface position will not be stored when 2 of the memory switches are pressed simultaneously (for example, M1 and M2) after first pressing the SET switch.

(3) Using the outer mirror switch assembly, turn the mirror surface to the full left position.

(4) Press the M2 switch.

(5) Check that the buzzer sounds for 0.1 seconds and the outer mirror automatically moves to the recorded full right position.