Installation

EXTERIOR: REAR BUMPER: INSTALLATION

1. INSTALL REAR BUMPER ASSEMBLY

(a) Install 2 new gaskets.

(b) Engage the 8 claws and install the rear bumper assembly as shown in the illustration.

HINT
Use the same procedure for the RH side and LH side.

(d) Install the screw.

HINT
Use the same procedure for the RH side and LH side.

(e) Install the 2 clips and 2 screws.

(f) Install the 2 nuts.

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

2. INSTALL REAR FLOOR FINISH PLATE Installation

3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Installation

4. INSTALL LUGGAGE COMPARTMENT SIDE TRAY ASSEMBLY Installation

5. INSTALL SPARE WHEEL COVER ASSEMBLY

6. INSTALL SPARE WHEEL COVER CLAMP

7. INSTALL LUGGAGE COMPARTMENT FLOOR MAT