Washer Nozzle (for Front Side)

WIPER / WASHER: WIPER AND WASHER SYSTEM: PRECAUTION

NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.





1. PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:

(1) the washer nozzle tip is made of resin and could be damaged.

(2) adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.






WIPER / WASHER: WASHER NOZZLE (for Front Side): ADJUSTMENT

1. ADJUST FRONT WASHER NOZZLE SUB-ASSEMBLY

(a) Select a washer nozzle so that the washer fluid spray area is within the standard range. Replace the washer nozzle with the selected one.