Installation

1AR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL TIMING CHAIN COVER OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
* Do not allow foreign matter to contact the lip of the oil seal.
* Do not allow MP grease to contact the dust seal.
(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.





SST : 09223-22010

NOTICE:
* Keep the lip of the oil seal free from foreign matter.
* Do not tap in the oil seal at an angle.
2. INSTALL CRANKSHAFT PULLEY

(a) Align the pulley set key with the key groove of the crankshaft pulley.

(b) Using SST, hold the crankshaft pulley and install the pulley bolt.





SST : 09213-54015

SST : 91551-80650

SST : 09330-00021

Torque : 260 Nm (2651 kgf-cm, 192 ft-lbf)

3. INSTALL V-RIBBED BELT Installation

4. INSTALL FRONT FENDER APRON SEAL RH Installation

5. INSTALL FRONT FENDER LINER RH

6. INSTALL NO. 1 ENGINE UNDER COVER

7. INSTALL FRONT WHEEL RH

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)