Removal

3MZ-FE ENGINE MECHANICAL: ENGINE REAR OIL SEAL:

REMOVAL

1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY

HINT: (Removal)

2. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY





(a) Using SST, hold the crankshaft.
SST: 09213-54015
91651-60855
SST: 09330-00021





(b) Remove the 8 bolts, rear spacer, drive plate and front spacer.
3. REMOVE ENGINE REAR OIL SEAL





(a) Using a knife, cut through the oil seal lip.
(b) Using a screwdriver with its tip wrapped in tape, pry out the oil seal.

NOTE: After the removal, check if the crankshaft is not damaged. If it is damaged, smooth the surface with 400-grit sandpaper.