Removal

1ZZ-FE ENGINE MECHANICAL: ENGINE REAR OIL SEAL:

COMPONENTS













REMOVAL

1. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)
(a) Remove the manual transaxle assembly (Removal).
2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY
(a) Remove the automatic transaxle assembly (Removal).
3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle)
(a) Remove the clutch cover assembly (Removal).
4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle)
(a) Remove the clutch disc assembly (Removal).
5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)





(a) Using SST, hold the crankshaft.
SST: 09960-10010
09962-01000
09963-01000
(b) Remove the 8 bolts and flywheel.
6. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)





(a) Using SST, hold the crankshaft.
SST: 09960-10010
09962-01000
09963-01000
(b) Remove the 8 bolts and drive plate & ring gear.
7. REMOVE ENGINE REAR OIL SEAL





(a) Using a knife, cut off the oil seal lip.
(b) Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

NOTE: After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.