Removal

BRAKE: BRAKE MASTER CYLINDER:

COMPONENTS









REMOVAL

1. DRAIN BRAKE FLUID

NOTE: Wash brake fluid off immediately if it adheres to any painted surface.

2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY
3. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
(a) Disconnect the brake fluid level switch connector from the reservoir sub-assembly.
(b) M/T:
Slide the clip and disconnect the clutch reservoir tube No. 1 from the reservoir sub-assembly.





(c) Using SST, disconnect the 2 brake tubes from the master cylinder sub-assembly.
SST: 09023-00101





(d) Using SST, disconnect the 2 or 3 brake tubes from the No. 1 way.
SST: 09023-00101





(e) Remove the 2 nuts, pull out the master cylinder sub-assembly and No. 1 way, and check the valve bracket.