Removal and Replacement

P/S Fluid Change

NOTE:

Using any fluid other than the specified P/S fluid may cause juddering or other faulty conditions.

Be sure to use only the specified P/S fluid.

1) Lift up vehicle.
2) Remove front under cover.
3) When engine is cool, remove P/S gear low pressure hose (1) from pipe and drain P/S fluid from low pressure hose.





4) Install low pressure hose to pipe.
5) Fill specified P/S fluid and bleed air referring to Service and Repair Air Bleeding of P/S System:Hydraulic Type.
6) Repeat Step 3) to 5) for 2 or 3 times if necessary.

P/S fluid specification
: Equivalent to ATF DEXRON�-II (ESSO JWS2326) or ATF DEXRON�-III

P/S fluid capacity reference value
: About 0.85 liters (1.8/1.5 US/Imp pt.)