Programming and Relearning

Sun Roof Motor Initialization

NOTE:

If an object is trapped during the sun roof motor initialization, the initialization is failed and the anti-pinching function is disabled.

Do not pinch any object during the sun roof motor initialization.

1) With ignition mode of keyless push start system in "ON", press "TILT UP"-side of sun roof switch to fully tilt up sun roof glass.
2) Keep pressing "TILT UP"-side of sun roof switch for 2 or more seconds. Sun roof glass will tilt down a little and initialization of sun roof motor is completed.
3) Conduct auto tilt down/up and auto slide open/close to check that auto functions work normally. (Repeat from Step 1) if any auto function is faulty.)
4) Conduct anti-pinching function check.

Anti-Pinching Function Check

NOTE:

If the sunroof pinches the hard part of the hammer handle or the like which is not wrapped with cloth, the roof of the vehicle may be damaged.

Make sure that the sunroof pinches the cloth-wrapped part of the hammer handle or the like.

1) Slide open the sun roof glass fully.
2) Place hammer handle wrapped with cloth close to fully closed position.











3) Conduct auto slide close of sun roof glass.
4) Check that sun roof glass reverses (open about 200 mm (7.87 in.)) automatically instead of pinching hammer handle.

If defect is found, replace sun roof motor.