P2135

DTC P2135

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

NOTE:

Confirm that the following conditions are met in this "DTC Confirmation Procedure".

- Battery voltage >= 11 V

1) Push engine switch to change ignition mode to "ON".
2) Run engine at idle speed for 2 sec.

DTC Troubleshooting


1. Was "Engine and Emission Control System Check" performed?
YES
Go to Step 2.
NO
Go to Engine and Emission Control System Check Engine and Emission Control System Check.
2. Wire harness check
Check the following points.
"C2" circuit: Refer to Step 2 through 5 of P0122 DTC P0122 / P0123.
"C3" circuit: Refer to Step 2 through 5 of P0222 DTC P0222 / P0223.
Are they in good condition?
YES
Go to Step 3.
NO
Repair or replace defective wire harness.
3. TP sensor check
Check TP sensor for performance referring to "TP Sensor Performance Check" under Testing and Inspection Electric Throttle Body Assembly On-Vehicle Inspection.
Is it in good condition?
YES
Replace ECM and recheck DTC. Service and Repair
NO
Replace throttle body assembly. Throttle Body Assembly Removal and Installation