P1825

DTC P1825

DTC Detecting Condition and Trouble Area






DTC Confirmation Procedure

1) Push engine switch to change ignition mode to "ON".
2) Push engine switch to change ignition mode to "OFF", and leave ignition mode in "OFF" for 10 sec.
3) Repeat Step 1).

DTC Troubleshooting


1. Was "CVT System Check" performed?
YES
Go to Step 2.
NO
Go to CVT System Check CVT System Check.
2. DTC check
Check DTC.
Is there DTC other than P1825?
YES
Go to troubleshooting for applicable DTC.
NO
Go to Step 3.
3. DTC recheck
Perform Programming and Relearning TCM Initialization and Learning Control.
Clear DTC. DTC Clearance
Confirm that ignition mode of keyless push start system is in "OFF".
Perform DTC confirmation procedure and check DTC.
Is DTC P1825 still detected?
YES
Substitute a known-good ROM (CVT assembly) and recheck DTC.
NO
End.