P0705

DTC P0705

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

NOTE:

Check that the following condition is satisfied when using this procedure.

- Battery voltage > 10.5 V

1) Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.

DTC Troubleshooting


1. Was "CVT System Check" performed?
YES
Go to Step 2.
NO
Go to CVT System Check CVT System Check.
2. Transmission range sensor circuit check for operation using SUZUKI scan tool
Confirm that ignition mode of keyless push start system is in "OFF".
Connect SUZUKI scan tool to DLC.
Push engine switch to change ignition mode to "ON".
Check transmission range signal ("P", "R", "N", "D") on scan tool display when shifting select lever to each range.
Is applicable range indicated?
YES
Go to Step 5.
NO
Go to Step 3.
3. Select cable adjustment check
Check select cable for adjustment. Procedures
Is it adjusted correctly?
YES
Go to Step 4.
NO
Adjust select cable and recheck DTC.
4. Transmission range sensor adjustment check
Check transmission range sensor for adjustment. Adjustments
Is it adjusted correctly?
YES
Go to Step 5.
NO
Adjust transmission range sensor and recheck DTC.
5. Transmission range sensor circuit signal check
Push engine switch to change ignition mode to "OFF".
Disconnect "C166", "E19" and "E20" connectors.
Check for proper terminal connection to "C166", "E19" and "E20" connectors.
If connections are OK, check the following points.
Resistance between each of "A1", "A2", "A3", "A4" and "A5" circuit terminals and each terminal at "C166" connector: infinity
Voltage of "A1", "A2", "A3", "A4" and "A5" circuits: 0 - 1 V (with ignition mode of keyless push start system in "ON")
Are they in good condition?
YES
Go to Step 6.
NO
Repair or replace defective wire harness.
6. Transmission range sensor check
Check transmission range sensor. Transmission Range Sensor Inspection
Is it in good condition?
YES
Substitute a known-good TCM and recheck DTC. Service and Repair
NO
Replace transmission range sensor. Transmission Range Sensor Removal and Installation