CVT

DTC P062F

DTC Detecting Condition and Trouble Area






DTC Confirmation Procedure

1) Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.

DTC Troubleshooting


1. DTC check
Clear DTC. DTC Clearance
Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 10 sec.
Push engine switch to change ignition mode to "ON" and check DTC.
Is DTC P062F still indicated?
YES
Go to Step 2.
NO
Check for intermittent trouble. Intermittent Connection and Poor Contact Inspection
2. TCM power supply and ground circuits check
Check TCM power supply and ground circuits. TCM Power Supply and Ground Circuit Check
Are they in good condition?
YES
Substitute a known-good TCM and recheck DTC. Service and Repair
NO
Repair or replace defective wire harness.