P0560

DTC P0560

DTC Detecting Condition and Trouble Area






Circuit Diagram














DTC Confirmation Procedure

1) Run engine at idle speed for 10 sec.

DTC Troubleshooting


1. Was "Engine and Emission Control System Check" performed?
YES
Go to Step 2.
NO
Go to Engine and Emission Control System Check Engine and Emission Control System Check.
2. Back-up power supply circuit check
Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect "C01" and "E01" connectors.
Check for proper terminal connection to "C01" and "E01" connectors.
If connections are OK, check that "F1" circuit and ground is battery voltage with ignition mode of keyless push start system in "ON".
Is it in good condition?
YES
Check for intermittent trouble. Intermittent Connection and Poor Contact Inspection
If OK, replace ECM and recheck DTC. Service and Repair
NO
"B/U" or "DOME" fuse blown, "F1" circuit is open or short to ground circuit, or charging system faulty.