P0461

DTC P0461

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Troubleshooting



1. Was "Engine and Emission Control System Check" performed?
YES
Go to Step 2.
NO
Go to Engine and Emission Control System Check Engine and Emission Control System Check.
2. DTC check
Check DTC.
Is there any CAN-DTC?
YES
Go to CAN DTC (Lost Communication and Communication Bus Off) Table CAN DTC (Lost Communication and Communication Bus Off) Table.
NO
Go to Step 3.
3. Fuel level sensor signal circuit check
Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect connectors from combination meter and fuel level sensor.
Check for proper terminal connection to combination meter connector and fuel level sensor connector.
If connections are OK, check the following points.
Resistance of "A1" circuit: less than 1
Resistance between "A1" circuit and ground: infinity
Resistance between "A1" circuit and each terminal at fuel level sensor connector: infinity
Voltage of "A1" circuit: 0 - 1 V (with ignition mode of keyless push start system in "ON")
Are they in good condition?
YES
2WD model: Go to Step 5.
4WD model: Go to Step 4.
NO
Repair or replace defective wire harness.
4. Sub fuel level sensor signal circuit check
Push engine switch to change ignition mode to "OFF".
Disconnect connector from sub fuel level sensor.
Check for proper terminal connection to sub fuel level sensor connector.
If connections are OK, check the following points.
Resistance of "A2" circuit: less than 1
Resistance between "A2" circuit and ground: infinity
Resistance between "A2" circuit and each terminal at sub fuel level sensor connector: infinity
Voltage of "A2" circuit: 0 - 1 V (with ignition mode of keyless push start system in ON)
Are they in good condition?
YES
Go to Step 5.
NO
Repair or replace defective wire harness.
5. Fuel level sensor ground circuit check
Check the following points.
Resistance of "A3" circuit: less than 3
Voltage of "A3" circuit and ground: 0 - 1 V (with ignition mode of keyless push start system in ON)
Are they in good condition?
YES
Go to Step 6.
NO
Repair or replace defective wire harness.
6. Fuel level sensor check
Check fuel level sensor. Fuel Level Sensor Inspection
Is it in good condition?
YES
Replace combination meter. Service and Repair
If DTC P0461 is still detected, replace ECM.
NO
Repair or replace defective parts.