P0707

DTC P0707





DTC Detecting Condition and Trouble Area

Wiring Diagram
Refer to DTC P0705. P0705

DTC Confirmation Procedure

WARNING:
^ When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
^ Road test should be carried out with 2 persons, a driver and a tester, on a level road.

NOTE:
^ If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected.
^ Check that the following conditions are satisfied when using this procedure.
- Battery voltage > 10.5 V

1) Drive vehicle at more than 10 km/h (6 mile/h) for 20 sec.
2) Stop vehicle and turn ignition switch to OFF position.
3) Repeat Step 1) through 2) twice.
4) Turn ignition switch to ON position.

DTC Troubleshooting

Step 1-3:

Step 3-7:

Step 7-9:

Table for Step 4