Front Suspension
REMOVAL1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front under cover.
3) Remove the front crossmember support plate.
4) Remove the stabilizer link.
5) Remove the stabilizer bracket.
INSTALLATION
Install each part in the reverse order of removal.
CAUTION:
^ Use a new flange nut.
^ Ensure the stabilizer bushing and stabilizer have the same identification colors.
^ Install the stabilizer bushing (front crossmember side) while aligning it with the paint mark on stabilizer.
^ The stabilizer bracket has a set orientation. Install it with the arrow mark facing the upper side of the vehicle.
Tightening torque:
Stabilizer link:
38 Nm (3.9 kgf-m, 28.0 ft-lb)
Stabilizer bracket:
25 Nm (2.5 kgf-m, 18.4 ft-lb)
Tie-rod end (castle nut):
27 Nm (2.75 kgf-m, 19.9 ft-lb)
INSPECTION
1) Check the bushing for abnormal cracks, fatigue or damage.
2) Check the stabilizer link for damage.