DTC 51

DTC 66 Neutral Position Switch Diagnostic Chart:

Inhibitor Switch Circuit:

DIAGNOSTIC CHART AND DIAGRAM

1. CHECK INPUT SIGNAL FOR ECU.
1) Turn ignition switch to "ON".
2) Measure voltage between ECU connector terminal and body when selector lever is on N position or others.


Connector & Terminal/Specified value
(B60) No. 10 - Body/0 V (N Range)
(B60) No. 10 - Body/8 V, min. (Other range)

Inhibitor Switch Connector:

2. CHECK INHIBITOR SWITCH.
1) Turn ignition switch to "OFF".
2) Disconnect bulkhead harness connector (B13).

3) Measure resistance between inhibitor switch terminal in connector (T1).


Connector & Terminal/Specified value
(T1) No. 1 - Body/0 ohm (N Range)
(T1) No. 1 - Body/1 M ohm min. (Other range)