Installation

TX6A AUTOMATIC TRANSMISSION / TRANSAXLE: TRANSMISSION WIRE: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL TRANSMISSION WIRE

(a) Coat a new O-ring with ATF and install it to the transmission wire.

(b) Install the transmission wire with the bolt.

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

(c) Connect the transmission wire connector.





HINT
Push up the lever until the claw of the transmission wire connector makes a connection sound.

2. CONNECT TRANSMISSION WIRE

(a) Connect the 9 solenoid valve connectors.

(b) Coat the ATF temperature sensor O-ring with ATF.

(c) Install the ATF temperature sensor and the temperature sensor clamp with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(d) Engage the wire harness clamp.

(e) Install the valve body wire harness clamp with the bolt.

Torque : 6.4 Nm (65 kgf-cm, 57 in-lbf)

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

(a) Coat a new O-ring with ATF and install it to the valve body oil strainer assembly.

(b) Install the valve body oil strainer assembly with the 4 bolts.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

4. INSTALL TRANSMISSION OIL CLEANER MAGNET

(a) Install the 3 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration.









5. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

(a) Install a new automatic transmission oil pan gasket and the automatic transmission oil pan sub-assembly with the 20 bolts.

Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

NOTICE:
Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.

6. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

Installation