Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: STEERING PAD: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL HORN BUTTON ASSEMBLY

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the 2 airbag connectors to the horn button assembly.









NOTICE:
* When connecting any airbag connector, take care not to damage the airbag wire harness.
* Be sure to only connect the connectors to each corresponding color.

(d) Push in the 2 locks to install the 2 airbag connectors.

(e) Connect the horn connector to the horn button assembly.

(f) Push the horn button assembly to engage the 3 pins carefully.





NOTICE:
* Make sure that the pins are securely inserted into the steering holes.
* Make sure to engage the 2 upper pins first.
* Make sure that the horn button assembly is securely installed.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 6.0 Nm (61 kgf-cm, 53 in-lbf)

3. INSPECT HORN BUTTON ASSEMBLY

(a) Make sure that the horn sounds.

If the horn does not sound, inspect the horn system Symptom Related Diagnostic Procedures.

4. PERFORM DIAGNOSTIC SYSTEM CHECK

Reading and Clearing Diagnostic Trouble Codes

5. INSPECT SRS WARNING LIGHT

Diagnosis System