Installation

FA20 ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION; 2013 MY FR-S [03/2012 -]

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply engine oil to the lip of a new rear engine oil seal.

NOTICE:
Keep the lip free of foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.





SST : 09223-15030

SST : 09950-70010

09951-07150

Oil seal tap in depth:

0 to 1.0 mm (0 to 0.0394 in.)

NOTICE:
* Wipe any extra grease off of the crankshaft.
* Keep the lip free of foreign matter.
* Do not tap on the oil seal at an angle.

2. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE

(a) Clean the 8 bolts and 8 bolt holes.

(b) Install the No. 1 crankshaft position sensor plate.









HINT
Align the pin of the front drive spacer with the pin hole of the crankshaft.

3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

(a) Using SST, hold the crankshaft pulley.





SST : 09960-10010

09962-01000

09963-01000

(b) Install the flywheel sub-assembly onto the crankshaft.

(c) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.





Torque : 85 Nm (867 kgf-cm, 63 ft-lbf)

4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transmission) Installation

5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transmission) Installation

6. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

(a) Using SST, hold the crankshaft pulley.





SST : 09960-10010

09962-01000

09963-01000

(b) Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

(c) In several steps, uniformly install and tighten the 8 bolts in the sequence shown in the illustration.





Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)

7. REMOVE MANUAL TRANSMISSION ASSEMBLY (for Manual Transmission)

Installation

8. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Installation

9. INSPECT FOR OIL LEAK