B1412

AIR CONDITIONING: AIR CONDITIONING SYSTEM: B1412: Ambient Temperature Sensor Circuit
B1412 - Ambient Temperature Sensor Circuit

DESCRIPTION

The ambient temperature sensor is installed in the front part of the condenser to detect the ambient temperature and control the air conditioner. The sensor is connected to the air conditioning amplifier and detects fluctuations in the ambient temperature. This data is used for controlling the room temperature. The sensor sends a signal to the air conditioning amplifier. The resistance of the ambient temperature sensor changes in accordance with the ambient temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases. The air conditioning amplifier applies a voltage (5 V) to the ambient temperature sensor and reads voltage changes as the resistance of the ambient temperature sensor changes.





WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM (AMBIENT TEMPERATURE SENSOR)

(a) Connect the Techstream to DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the tester on.

(d) Select the following menus: Body Electrical / Air Conditioner / Data List / Ambient Temp Sensor

(e) According to the display on tester, read the "Data List".

Ambient Temp Sensor:





OK:

The display is as specified in the normal condition column.

Result:





B -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE Symptom Related Diagnostic Procedures

C -- REPLACE AIR CONDITIONING AMPLIFIER Removal
A -- Continue to next step.

2. INSPECT AMBIENT TEMPERATURE SENSOR

(a) Remove the ambient temperature sensor Removal.





(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NOTICE:
* Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
* When measuring, the sensor temperature must be the same as the ambient temperature.

HINT
As the temperature increases, the resistance decreases (see the graph).

(c) Reinstall the ambient temperature sensor.

NG -- REPLACE AMBIENT TEMPERATURE SENSOR Removal
OK -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (AMBIENT TEMPERATURE SENSOR - COMBINATION METER)

(a) Disconnect the B4 ambient temperature sensor connector.





(b) Disconnect the G7 air conditioning amplifier connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





(d) Reconnect the ambient temperature sensor connector.

(e) Reconnect the air conditioning amplifier connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE AIR CONDITIONING AMPLIFIER Removal