Installation

WIPER / WASHER: REAR WIPER MOTOR: INSTALLATION

1. INSTALL REAR WIPER MOTOR GROMMET

(a) Apply MP grease to the entire surface of the wiper motor grommet lip.





Text in Illustration





HINT
Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

(b) Install the rear wiper motor grommet with the mark directed up.





Text in Illustration





2. INSTALL REAR WIPER MOTOR ASSEMBLY

(a) Install the rear wiper motor with the 3 bolts.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

(b) Connect the connector.

3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

(a) Clean any metal powder off the serrated part of the wiper arm with a round wire brush or the equivalent (when reinstalling).

Text in Illustration









(b) Clean the wiper pivot serrations with a wire brush.

(c) Operate the wiper, and then stop the rear wiper motor in the automatic stop position.

(d) Install the rear wiper arm into the position shown in the illustration with the nut.

Text in Illustration





Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

HINT
Hold the arm hinge down by hand while tightening the nut.





(e) Close the rear wiper arm head cap.





4. INSTALL BACK DOOR TRIM BOARD Reassembly