Installation

1NR-FE LUBRICATION: OIL PRESSURE SWITCH: INSTALLATION

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

(a) Apply adhesive to 2 or 3 threads of the oil pressure switch.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

(b) Using a 24 mm deep socket wrench, install the oil pressure switch.

Torque : 15 Nm (153 kgf-cm, 11 ft-lbf)

NOTICE:
Do not start the engine for at least 1 hour after installation.

(c) Connect the oil pressure switch connector.

2. INSTALL COOLER COMPRESSOR ASSEMBLY

Installation

3. INSPECT FOR ENGINE OIL LEAK