Installation

1NR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL





(a) Remove any old packing material and be careful not to drop any oil on the contact surfaces of the oil pan and cylinder block.

(b) Apply seal packing in a continuous bead as shown in the illustration.

Seal packing:

Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

NOTICE:
* Remove any oil from the contact surfaces.
* Install a new rear engine oil seal within 3 minutes after applying seal packing.
* Do not start the engine for at least 2 hours after installing.

(c) Wipe off the excess seal packing, leaving only the specified amount in the areas shown in the illustration.





Text in Illustration





(d) Apply MP grease to the lip of a new rear engine oil seal.

NOTICE:
Keep the lip free from foreign matter.

(e) Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the cylinder block and oil pan.





SST : 09950-70010

09951-07150

SST : 09223-47020

Oil seal tap in depth:

-0.2 to 1.2 mm (-0.0079 to 0.0472 in.)

NOTICE:
* Uniformly tap in the oil seal.
* Do not tap the rear engine oil seal at an angle.
* Wipe off extra grease from the crankshaft.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

(a) Using SST, hold the crankshaft.

SST : 09960-10010

09962-01000

09963-01000

(b) Install the front drive plate spacer, the drive plate and ring gear and the rear drive plate spacer to the crankshaft.





Text in Illustration





HINT
* The front spacer is reversible.
* As the rear drive plate spacer and the drive plate are not reversible, be sure to install them in the direction shown in the illustration.

(c) Clean the 8 bolts and their holes.

(d) Apply adhesive to 2 or 3 end threads of each of the 8 bolts.





Text in Illustration





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

(e) Install and uniformly tighten the 8 bolts in several steps in sequence shown in the illustration.





Torque : 88 Nm (897 kgf-cm, 65 ft-lbf)

NOTICE:
Do not start the engine for at least an hour after installing the drive plate.

3. INSTALL CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY

Installation