C1407

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: VEHICLE STABILITY CONTROL SYSTEM: C1407, C1408: Open or Short in Rear Speed Sensor RH Circuit
C1408 - Open or Short in Rear Speed Sensor LH Circuit

DESCRIPTION

Refer to DTCs C1403 and C1404 C1403.

HINT
* DTC C1407 is for the rear speed sensor RH.
* DTC C1408 is for the rear speed sensor LH.

WIRING DIAGRAM

Refer to DTCs C1403 and C1404 C1403.

INSPECTION PROCEDURE

NOTICE:
* When replacing the brake actuator assembly, perform zero point calibration Programming and Relearning.
* Disassembly of the rear speed sensor from the rear axle hub and bearing assembly is prohibited.
* Check the speed sensor signal after replacement Test Mode Procedure.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (MOMENTARY INTERRUPTION)

(a) Using the Techstream, check for any momentary interruption in the wire harness and connector corresponding to the DTC Check for Intermittent Problems.

ABS/VSC/TRAC

OK:

There are no momentary interruptions.

HINT
Perform the above inspection before removing the sensor and connector.

NG -- INSPECT SKID CONTROL SENSOR WIRE
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (REAR SPEED SENSOR) C1403

NG -- INSPECT SKID CONTROL SENSOR WIRE
OK -- Continue to next step.

3. RECONFIRM DTC

(a) Turn the ignition switch off.

(b) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

(c) Start the engine.

(d) Drive the vehicle at a speed of 40 km/h (25 mph) or more for at least 60 seconds.

(e) Check if the same DTC is recorded Reading and Clearing Diagnostic Trouble Codes.

Result

HINT
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step Problem Symptoms Table.

B -- REPLACE BRAKE ACTUATOR ASSEMBLY Removal

A -- CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) Check for Intermittent Problems

4. INSPECT SKID CONTROL SENSOR WIRE

(a) Remove the skid control sensor wire.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for RH
for LH

Text in Illustration

(c) Install the skid control sensor wire.

NG -- REPLACE SKID CONTROL SENSOR WIRE
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - REAR SPEED SENSOR)

(a) Turn the ignition switch off.

(b) Make sure that there is no looseness at the locking part and the connecting part of the connectors.

(c) Disconnect the skid control ECU connector and the rear speed sensor connector.

(d) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

for RH
for LH

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. INSPECT SKID CONTROL ECU (SENSOR INPUT)

(a) Reconnect the skid control ECU connector.

(b) Turn the ignition switch to ON.

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

for RH
for LH

Text in Illustration