Replacement

U341E AUTOMATIC TRANSAXLE: DIFFERENTIAL OIL SEAL: REPLACEMENT

1. REMOVE ENGINE UNDER COVER

2. DRAIN AUTOMATIC TRANSAXLE FLUID

(a) Remove the drain plug and gasket, and drain the ATF.

(b) Install a new gasket and the drain plug.

Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)

3. REMOVE FRONT WHEEL

4. REMOVE FRONT AXLE HUB NUT Removal

5. SEPARATE FRONT SPEED SENSOR Removal

6. SEPARATE FRONT STABILIZER LINK ASSEMBLY Removal

7. SEPARATE TIE ROD END SUB-ASSEMBLY Removal

8. SEPARATE FRONT LOWER SUSPENSION ARM Removal

9. SEPARATE FRONT AXLE ASSEMBLY Removal

10. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH Removal

11. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH Removal

12. REMOVE FRONT TRANSAXLE CASE OIL SEAL

(a) Using SST, remove the front transaxle case oil seal.





SST : 09308-00010

13. REMOVE TRANSAXLE CASE OIL SEAL

(a) Using SST, remove the transaxle case oil seal.





SST : 09308-00010

14. INSTALL TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new transaxle case oil seal with MP grease.

(b) Using SST and a hammer, install the transaxle case oil seal.





SST : 09710-20011

09710-06071

SST : 09950-70010

09951-07200

Drive in depth:

2.2 to 3.2 mm (0.087 to 0.126 in.)

NOTICE:
Do not damage the oil seal lip.

15. INSTALL FRONT TRANSAXLE CASE OIL SEAL

(a) Coat the lip of a new front transaxle case oil seal with MP grease.

(b) Using SST and a hammer, install the front transaxle case oil seal.





SST : 09554-14010

SST : 09950-70010

09951-07200

Drive in depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

NOTICE:
Do not damage the oil seal lip.

16. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH Installation

17. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH Installation

18. INSTALL FRONT AXLE ASSEMBLY Installation

19. INSTALL FRONT LOWER SUSPENSION ARM Installation

20. INSTALL TIE ROD END SUB-ASSEMBLY Installation

21. INSTALL FRONT STABILIZER LINK ASSEMBLY Installation

22. INSTALL FRONT SPEED SENSOR Installation

23. INSTALL FRONT AXLE HUB NUT Installation

24. INSTALL FRONT WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

25. ADD AUTOMATIC TRANSAXLE FLUID

26. INSPECT AUTOMATIC TRANSAXLE FLUID Procedures

27. INSPECT FOR AUTOMATIC TRANSAXLE FLUID LEAK

28. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT
Front Wheel Alignment

29. CHECK VSC SENSOR SIGNAL

HINT
Test Mode Procedure

30. INSTALL ENGINE UNDER COVER

Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)