Installation

AUDIO / VISUAL: RADIO ANTENNA CORD: INSTALLATION

1. INSTALL ANTENNA CORD SUB-ASSEMBLY

NOTICE:
* Apply the tape securely in place.
* Do not touch the adhesive surface when applying the tape to prevent adhesion failure.





(a) Clamp the sections of the antenna cord with red tape to the side rail spacer in 2 locations, align with the marking of the roof headlining, and fasten with tape in 1 location.

(b) Clamp the section of the antenna cord with pink tape to the side rail spacer in 1 location, align with the marking of the roof headlining, and fasten with tape in 2 locations.

(c) Align with the marking of the roof headlining and fasten with tape in 3 locations.

(d) Insert the antenna cord through the slit in the roof headlining.

2. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY





(a) Install the 5 clamps.

(b) Connect the connector.

(c) Install the bolt.

Torque : 7.0 Nm (71 kgf-cm, 62 in-lbf)

3. INSTALL ROOF HEADLINING ASSEMBLY Installation

4. INSTALL REAR SHOULDER BELT ANCHOR COVER Installation

5. INSTALL SEAT BELT ANCHOR COVER Installation

6. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY Installation

7. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation

8. INSTALL COMBINATION METER ASSEMBLY Removal

9. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation

10. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

11. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY Installation

12. INSTALL MAP LIGHT ASSEMBLY Installation

13. INSTALL ROOM LIGHT ASSEMBLY Installation

14. INSTALL VISOR HOLDER RH Installation

15. INSTALL VISOR HOLDER LH Installation

16. INSTALL VISOR ASSEMBLY RH Installation

17. INSTALL VISOR ASSEMBLY LH Installation

18. INSTALL ASSIST GRIP Installation

19. INSTALL FRONT PILLAR GARNISH RH Installation

20. INSTALL FRONT PILLAR GARNISH LH Installation

21. INSTALL CENTER PILLAR UPPER GARNISH RH Installation

22. INSTALL CENTER PILLAR UPPER GARNISH LH Installation

23. INSTALL CENTER PILLAR LOWER GARNISH RH Installation

24. INSTALL CENTER PILLAR LOWER GARNISH LH Installation

25. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH Installation

26. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH Installation

27. INSTALL SEAT BELT ANCHOR COVER CAP Installation

28. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

29. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

30. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation

31. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Installation

32. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation

33. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH Installation

34. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

35. INSTALL REAR DECK TRIM COVER Installation

36. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

37. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation

38. INSTALL REAR DOOR SCUFF PLATE RH Installation

39. INSTALL REAR DOOR SCUFF PLATE LH Installation

40. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation

41. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation

42. INSTALL COWL SIDE TRIM BOARD RH Installation

43. INSTALL COWL SIDE TRIM BOARD LH Installation

44. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

45. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

46. INSTALL FRONT DOOR SCUFF PLATE RH Installation

47. INSTALL FRONT DOOR SCUFF PLATE LH Installation

48. INSTALL REAR SEAT ASSEMBLY RH Installation

49. INSTALL REAR SEAT ASSEMBLY LH Installation

50. INSTALL NO. 1 REAR SEAT LEG COVER RH Installation

51. INSTALL NO. 1 REAR SEAT LEG COVER LH Installation

52. INSTALL NO.2 REAR SEAT LEG COVER LH Installation

53. INSTALL DECK BOARD ASSEMBLY Installation

54. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

55. INSPECT SRS WARNING LIGHT

Diagnosis System