Clutch Unit

CLUTCH: CLUTCH UNIT: INSPECTION

1. INSPECT CLUTCH DISC ASSEMBLY





(a) Using a vernier caliper, measure the rivet head depth.

Minimum rivet depth:

0.3 mm (0.0118 in.)

If the depth is less than the minimum, replace the clutch disc assembly.

(b) Install the clutch disc assembly to the transaxle assembly.

HINT
Insert the clutch disc assembly so that it faces in the correct direction.

(c) Using a dial indicator, measure the clutch disc assembly runout.





Maximum runout:

0.8 mm (0.0314 in.)

If the runout is more than the maximum, replace the clutch disc assembly.

2. INSPECT CLUTCH COVER ASSEMBLY





(a) Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

Text in Illustration





Maximum width:

6.0 mm (0.236 in.)

Maximum depth:

0.5 mm (0.0196 in.)

If the depth or width is more than the maximum, replace the clutch cover assembly.

3. INSPECT FLYWHEEL SUB-ASSEMBLY





(a) Using a dial indicator, check the flywheel sub-assembly runout.

Maximum runout:

0.1 mm (0.00393 in.)

If the runout is more than the maximum, replace the flywheel sub-assembly.