Installation

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: VALVE BODY ASSEMBLY: INSTALLATION

1. INSTALL MANUAL VALVE

(a) Coat the manual valve with ATF and install it to the transmission valve body assembly.

2. INSTALL NO.1 GOVERNOR APPLY GASKET

(a) Coat 2 new No. 1 governor apply gaskets with ATF.

(b) Install the 2 No. 1 governor apply gaskets onto the transaxle case.

3. INSTALL TRANSMISSION VALVE BODY ASSEMBLY

(a) Coat the O-ring of the transmission wire with ATF.

(b) Confirm that the manual valve lever is positioned as shown in the illustration and install the transmission valve body assembly to the transaxle case with the 11 bolts.





Text in Illustration





Bolt A, B, C - Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)

Bolt D - Torque : 9.6 Nm (98 kgf-cm, 85 in-lbf)

Bolt length:

Bolt A
25 mm (0.984 in.)

Bolt B
30 mm (1.18 in.)

Bolt C, D
35 mm (1.38 in.)

NOTICE:
* When installing the transmission valve body assembly, be careful not to allow the speed sensor and transaxle case to interfere with each other.
* Be sure to insert the pin of the manual valve lever into the groove on the end of the manual valve.
* First, temporarily install the bolts marked *a in the illustration because they are positioning bolts.

4. INSTALL VALVE BODY OIL STRAINER ASSEMBLY Reassembly

5. INSTALL TRANSMISSION OIL CLEANER MAGNET Reassembly

6. INSTALL AUTOMATIC TRANSAXLE OIL PAN GASKET Reassembly

7. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY Reassembly

8. ADJUST AUTOMATIC TRANSAXLE FLUID

Service and Repair

9. INSTALL NO. 1 ENGINE UNDER COVER Installation