Removal

U760E AUTOMATIC TRANSMISSION / TRANSAXLE: PARK / NEUTRAL POSITION SWITCH: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE AIR CLEANER CAP AND HOSE Removal

3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY Removal

4. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Move the shift lever to N.





(b) Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

5. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Disconnect the park/neutral position switch connector.

(b) Detach the 2 wire harness clamps.





(c) Remove the nut, spring washer and transmission control shaft lever.





(d) Remove the 2 bolts and park/neutral position switch assembly.





NOTICE:
Before removing the park/neutral position switch, remove any dirt or rust on the installation portion of the control shaft. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.