Removal

SEAT BELT: FRONT SEAT INNER BELT ASSEMBLY: REMOVAL

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
When removing the front seat assembly RH, perform zero point calibration and the sensitivity check Programming and Relearning.

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. REMOVE FRONT SEAT ASSEMBLY LH

Removal

2. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

(a) Disconnect the connector from the seat position airbag sensor.





(b) Disconnect the wire harness from the seat slide position sensor protector.

(c) Detach the claw and disconnect the connector from the front seat cushion spring.





(d) Detach the 6 wire harness clamps.

(e) Remove the nut and front seat inner belt.





3. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

(a) Disconnect the connector and detach the wire harness clamp.





(b) Remove the nut and front seat inner belt.