Removal

SUPPLEMENTAL RESTRAINT SYSTEMS: CURTAIN SHIELD AIRBAG ASSEMBLY: REMOVAL

CAUTION:
Be sure to read Precaution thoroughly before servicing Service Precautions.

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE ROOF HEADLINING ASSEMBLY

Removal

3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

(a) Pull the lock plate to release the connector lock.

Text in Illustration









(b) Disconnect the airbag connector.

NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

(c) Disconnect the deployment section of the curtain shield airbag from the vehicle body.





(1) Using a clip remover, remove the 6 pins.





Text in Illustration





(2) Using a screwdriver, detach the 12 claws and disconnect the deployment section of the curtain shield airbag from the vehicle body.





Text in Illustration





HINT
Tape the screwdriver tip before use.

(d) Remove the 2 bolts.





(e) Detach the 2 hooks and remove the curtain shield airbag.

(f) Detach the 12 claws and remove the 6 clips and 6 spacers from the curtain shield airbag.





Text in Illustration