Removal

2AR-FE FUEL: FUEL INJECTOR: REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE

Fuel System: Precaution

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

3. REMOVE WINDSHIELD WIPER MOTOR AND LINK

Removal

4. REMOVE OUTER COWL TOP PANEL

(a) Remove the 9 bolts and outer cowl top panel.





5. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Removal

6. DISCONNECT FUEL HOSE BRACKET

(a) Remove the bolt and disconnect the fuel hose bracket.





Text in Illustration





NOTICE:
If the fuel hose is detached from the clamp shown in the illustration, the clamp cannot be reused.

7. DISCONNECT FUEL TUBE SUB-ASSEMBLY

NOTICE:
Do not forcibly bend, kink or twist the fuel tube.

(a) Remove the No. 2 fuel pipe clamp.





Text in Illustration





(b) Wipe off any dirt on the fuel tube connector.

(c) Hold the fuel tube connector, and then install SST.

SST : 09268-21011

(d) Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.

(e) Insert SST into the fuel tube and hold it. Then push the fuel tube connector toward SST.

(f) Mount the retainer of the fuel tube connector onto the chamfered part of SST.

(g) Slide SST and the fuel tube connector together towards the fuel tube until they make a "click" sound, and then disconnect the fuel tube.





Text in Illustration





(h) Drain the fuel remaining inside the fuel tube.

(i) Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected parts.

8. DISCONNECT WIRE HARNESS

(a) Disconnect the 4 fuel injector connectors.





(b) Disconnect the 2 connectors.

(c) Remove the 3 bolts and 3 wire harness brackets.

(d) Detach the clamp and disconnect the wire harness.

9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

(a) Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injectors.





NOTICE:
Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

(b) Remove the 2 fuel delivery spacers from the cylinder head.





(c) Remove the 4 injector vibration insulators from the cylinder head.

10. REMOVE FUEL INJECTOR ASSEMBLY

(a) Pull the 4 fuel injectors out of the fuel delivery pipe.





Text in Illustration





(b) Remove the O-ring.