Removal

2AR-FE EMISSION CONTROL: CANISTER: REMOVAL

1. REMOVE MAIN MUFFLER HEAT INSULATOR

(a) Remove the 4 nuts and main muffler heat insulator.





2. REMOVE CANISTER

(a) Disconnect the connector.





Text in Illustration





(b) Disconnect the purge line hose.

(c) Disconnect the air inlet line hose.

(1) Push the hose firmly toward the canister side.

(2) Pinch the hose as shown in the illustration.

(3) Pull out the hose.

NOTICE:
* Do not use any tools in this procedure.
* Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the canister and hose.

(d) Disconnect the vent line hose.

(1) Pinch the retainer and then raise it.

NOTICE:
* Do not use any tools in this procedure.
* Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-ring or cause leaks in the seal between the canister and hose.

(e) Remove the 3 bolts and clip, detach the claw and remove the canister.