Operation Check

METER / GAUGE / DISPLAY: METER / GAUGE SYSTEM: OPERATION CHECK

1. INSPECT INDICATOR/WARNING LIGHT

(a) Check the following indicators and warning lights.





* *1: w/ MAINT REQD Indicator Light

* *2: w/ Washer Level Warning Light

* *3: for Automatic Transaxle

* *4: w/ Tire Pressure Warning System

2. INSPECT SPEEDOMETER

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Data List.

Reference:

for U.S.A.





for Canada





If the result is not as specified, the speedometer may have a malfunction.

NOTICE:
Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.

(e) Check the deflection width of the speedometer indicator.

Reference:

Within 0.3°

3. INSPECT TACHOMETER

(a) Connect a tune-up tachometer and start the engine.

(b) Compare the test results with the tachometer indicator.

DC 13.5 V at 25°C (77°F):





If the result is not as specified, the tachometer may have a malfunction.

4. INSPECT METER/GAUGE

(a) Connect the Techstream to the DLC3.

(b) Perform the Active Test Meter / Gauge System.

OK:

Each meter/gauge needle indication is normal.

5. INSPECT WARNING/INDICATOR LIGHT

(a) Connect the Techstream to the DLC3.

(b) Perform the Active Test Meter / Gauge System.

OK:

Each warning/indicator light can be turned on and off using the Techstream.