Installation

2AR-FE ENGINE MECHANICAL: REAR CRANKSHAFT OIL SEAL: INSTALLATION

1. INSTALL REAR ENGINE OIL SEAL

(a) Apply MP grease to the lip of a new oil seal.

NOTICE:
* Do not allow foreign matter to contact the lip of the oil seal.
* Do not allow MP grease to contact the dust seal.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.





SST : 09223-15030

SST : 09950-70010

09951-07150

NOTICE:
* Keep the lip of the oil seal free from foreign matter.
* Do not tap in the oil seal at an angle.

2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transaxle)

(a) Using SST, hold the crankshaft.





SST : 09213-54015

SST : 91551-80650

SST : 09330-00021

(b) Clean the bolts and their installation holes.

(c) Install the front drive plate spacer.





HINT
Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

(d) Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.





Text in Illustration





HINT
* The front drive plate spacer is reversible.
* As the rear drive plate spacer and the drive plate and ring gear are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

(e) Apply a few drops of adhesive to 2 or 3 threads at the end of the bolt.





Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Text in Illustration





(f) Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.





Torque : 98 Nm (999 kgf-cm, 72 ft-lbf)

NOTICE:
Do not start the engine for at least an hour after installing the drive plate.

3. INSTALL FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle)

(a) Using SST, hold the crankshaft.





(b) Clean the bolts and bolt holes.





(c) Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

Text in Illustration





(d) Install the flywheel with the 8 bolts. Uniformly tighten the 8 bolts in the sequence shown in the illustration.





Torque : 130 Nm (1326 kgf-cm, 96 ft-lbf)

4. INSTALL CLUTCH DISC ASSEMBLY (for Manual Transaxle) Installation

5. INSTALL CLUTCH COVER ASSEMBLY (for Manual Transaxle) Installation

6. FIX ENGINE ASSEMBLY Removal

7. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle)

Installation

8. INSTALL MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle)

Installation

9. INSTALL ENGINE AND TRANSAXLE

Installation