Removal

AUDIO / VIDEO: FRONT DOOR SPEAKER: REMOVAL

HINT
* Use the same procedure for the RH and LH sides.
* The procedure listed below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH Disassembly

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH Disassembly

4. REMOVE DOOR ASSIST GRIP COVER LH Disassembly

5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) Disassembly

6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) Disassembly

7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH Disassembly

8. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

NOTICE:
Do not touch the cone part of the speaker.

(a) Disconnect the speaker connector.

(b) Using a drill bit with a diameter of less than 4 mm (0.157 in.), drill out the 4 rivet heads.





CAUTION:
Be careful as the cut rivet will be very hot.

NOTICE:
Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.

(c) Continue drilling and push out the remaining rivet fragments.

(d) Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

(e) Detach the 2 claws and remove the front No. 1 speaker.

9. REMOVE FRONT NO. 2 SPEAKER ASSEMBLY

(a) Disconnect the connector.





(b) Remove the 2 screws and front No. 2 speaker.

10. REMOVE FRONT NO. 3 SPEAKER ASSEMBLY

(a) Detach the 3 claws and front No. 3 speaker.