C2173

TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING SYSTEM: C2173/73: Vehicle Speed or Engine Speed Signal Malfunction
C2173/73 - Vehicle Speed or Engine Speed Signal Malfunction

DESCRIPTION

The tire pressure warning ECU receives a vehicle speed signal from the combination meter and an engine speed signal from the ECM. The tire pressure warning ECU uses these signals to store DTCs C2121/21 to C2124/24.





HINT
This DTC is stored at the same time DTCs C2121/21 to C2124/24 are stored.

WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
* When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
* It is necessary to perform initialization Initialization after registration Registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or the tire pressure warning valve and transmitter has been replaced.

PROCEDURE

1. PERFORM SIGNAL CHECK (VEHICLE SPEED SIGNAL AND ENGINE SPEED SIGNAL)

(a) Enter signal check mode in the Test Mode Procedure Test Mode Procedure.

(b) Drive the vehicle at 20 km/h (12 mph) or more for 10 seconds to clear DTCs C2191/91 and C2194/94.

(c) Check the test mode DTCs.

Result





HINT
DTCs C2181/81 to C2184/84 (Transmitter ID not Received) are output at this time, but they are not related to this check.

C -- GO TO DTC C2194/94 C2194

B -- GO TO DTC C2191/91 C2191

A -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting