Removal

BRAKE CONTROL: BRAKE ACTUATOR: REMOVAL

1. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.

2. REMOVE COWL TOP VENTILATOR LOUVER CENTER Service and Repair

3. REMOVE BATTERY Removal

4. REMOVE BATTERY TRAY

5. REMOVE BATTERY CARRIER Removal

6. REMOVE BRAKE ACTUATOR ASSEMBLY

(a) Release the lock lever and disconnect the brake actuator connector.





NOTICE:
Be careful not to allow brake fluid to enter the removed connector.

(b) Using a union nut wrench, separate the 6 brake tubes from the brake actuator.





(c) Use tags or labels to identify the place to reconnect each brake tube.





HINT
* *1: To front wheel cylinder RH
* *2: To front wheel cylinder LH
* *3: To rear wheel cylinder RH
* *4: To rear wheel cylinder LH
* *5: From 1st master cylinder
* *6: From 2nd master cylinder
(d) Remove the 3 bolts and brake actuator with bracket.





NOTICE:
Do not damage the brake tubes or wire harness.

7. REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY

(a) Remove the 4 bolts and actuator bracket.