Installation

CLUTCH: CLUTCH ACCUMULATOR: INSTALLATION

1. INSTALL CLUTCH ACCUMULATOR ASSEMBLY





(a) Install the clutch accumulator with the 2 bolts and 2 nuts.

Torque : 12 Nm (120 kgf-cm, 9 ft-lbf for bolt A)

Torque : 37 Nm (377 kgf-cm, 27 ft-lbf for bolt B)

2. INSTALL RELEASE CYLINDER HEAT INSULATOR





(a) Install the release cylinder heat insulator with the 2 bolts.

Torque : 12 Nm (120 kgf-cm, 9 ft-lbf)

3. CONNECT FLEXIBLE HOSE TUBE





(a) Using a union nut wrench, connect the 2 flexible hose tubes.

without union nut wrench - Torque : 15 Nm (154 kgf-cm, 11 ft-lbf)

with union nut wrench - Torque : 14 Nm (143 kgf-cm, 10 ft-lbf)

NOTICE:
* This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.886 in.) Service Precautions.
* This torque value is effective when the union nut wrench is parallel to a torque wrench.
4. BLEED CLUTCH LINE

5. INSPECT FOR CLUTCH FLUID LEAK

6. INSPECT BRAKE FLUID LEVEL IN RESERVOIR