Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Service Precautions.

HINT
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

(a) Check that the ignition switch is off.

(b) Check that the battery negative (-) terminal is disconnected.

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Install 4 new clips and 4 new spacers to the curtain shield airbag assembly as shown in the illustration.





HINT
* Do not push in the pin.
* Make sure that the clips are installed in the correct direction.
* Make sure that the spacers are installed properly, in the correct direction, and that they are not damaged.
(d) Install the curtain shield airbag assembly with 6 new bolts.





Torque : 13 Nm (133 kgf-cm, 10 ft-lbf)

NOTICE:
Do not twist the curtain shield airbag assembly when installing it.

(e) Install the 4 clips with the curtain shield airbag assembly to the body panel as shown in the illustration.





NOTICE:
Make sure that the pins of the clips are pushed in firmly.

(f) Mark the clips.

HINT
Mark the clips to make sure that they are not reused.

(g) Connect the airbag connector.





NOTICE:
Securely lock the locking button.

2. INSTALL ROOF HEADLINING Installation

3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY Installation

4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY Installation

5. INSTALL COMBINATION METER ASSEMBLY Installation

6. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Installation

7. INSTALL INSTRUMENT CLUSTER FINISH LOWER PANEL Installation

8. INSTALL INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY Installation

9. INSTALL MAP LIGHT ASSEMBLY Installation

10. INSTALL ROOM LIGHT ASSEMBLY Installation

11. INSTALL VISOR HOLDER Installation

12. INSTALL VISOR ASSEMBLY RH Installation

13. INSTALL VISOR ASSEMBLY LH Installation

14. INSTALL ASSIST GRIP Installation

15. INSTALL FRONT PILLAR GARNISH RH Installation

16. INSTALL FRONT PILLAR GARNISH LH Installation

17. INSTALL CENTER PILLAR UPPER GARNISH RH Installation

18. INSTALL CENTER PILLAR UPPER GARNISH LH Installation

19. INSTALL CENTER PILLAR LOWER GARNISH RH Installation

20. INSTALL CENTER PILLAR LOWER GARNISH LH Installation

21. INSTALL FRONT SEAT OUTER BELT ASSEMBLY RH Installation

22. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH Installation

23. INSTALL SEAT BELT ANCHOR COVER CAP Installation

24. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

25. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

26. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Installation

27. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH Installation

28. INSTALL REAR SEAT OUTER BELT ASSEMBLY RH Installation

29. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH Installation

30. INSTALL REAR SEAT BACK HINGE Installation

31. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY Installation

32. INSTALL REAR DECK TRIM COVER Installation

33. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH Installation

34. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH Installation

35. INSTALL REAR DOOR SCUFF PLATE RH Installation

36. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH Installation

37. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation

38. INSTALL COWL SIDE TRIM BOARD RH Installation

39. INSTALL COWL SIDE TRIM BOARD LH Installation

40. INSTALL FRONT DOOR SCUFF PLATE RH Installation

41. INSTALL FRONT DOOR SCUFF PLATE LH Installation

42. INSTALL REAR SEATBACK ASSEMBLY RH Installation

43. INSTALL REAR SEATBACK ASSEMBLY LH Installation

44. INSTALL REAR SEAT CUSHION WITH COVER PAD SUB-ASSEMBLY Installation

45. INSTALL DECK FLOOR BOX RH Installation

46. INSTALL DECK FLOOR BOX LH Installation

47. INSTALL REAR DECK FLOOR BOX Installation

48. INSTALL REAR FLOOR CARPET ASSEMBLY Installation

49. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

50. INSPECT SRS WARNING LIGHT

Diagnosis System