Removal

2AZ-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: REMOVAL

1. REMOVE FRONT WHEEL RH

2. REMOVE REAR ENGINE UNDER COVER RH

3. REMOVE FAN & GENERATOR V BELT Removal

4. REMOVE CRANKSHAFT PULLEY

(a) Using SST, hold the pulley in place and loosen the pulley bolt.

SST : 09213-54015

91651-60855

SST : 09330-00021





(b) Using SST, remove the crankshaft pulley.





SST : 09950-50013

09951-05010

09952-05010

09953-05020

09954-05021

SST : 09950-40011

09957-04010

HINT
If necessary, remove the pulley and pulley bolt using SST.

5. REMOVE FRONT CRANKSHAFT OIL SEAL

(a) Using a knife, cut off the lip of the oil seal.





(b) Using a screwdriver, pry out the oil seal.

NOTICE:
Do not damage the surface of the oil seal press fit hole and crankshaft.

HINT
Tape the screwdriver tip before use.