Installation

E350 MANUAL TRANSAXLE: DIFFERENTIAL OIL SEAL: INSTALLATION

1. INSTALL TRANSMISSION CASE OIL SEAL





(a) Coat the lip of a new oil seal with MP grease.

(b) Using SST and a hammer, tap in the oil seal.

SST : 09608-32010

SST : 09950-70010

09951-07200

Standard depth:

3.0 to 4.0 mm (0.118 to 0.158 in.)

NOTICE:

Be careful not to damage the lip of the oil seal.

2. INSTALL FRONT TRANSAXLE CASE COVER OIL SEAL





(a) Coat the lip of a new oil seal with MP grease.

(b) Using SST and a hammer, tap in the oil seal.

SST : 09608-10010

SST : 09950-70010

09951-07200

Standard depth:

-0.5 to 0.5 mm (-0.020 to 0.020 in.)

NOTICE:

Be careful not to damage the lip of the oil seal.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

(a) Install drive shaft Installation.

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

(a) Install drive shaft Installation.

5. INSTALL FRONT WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

6. ADD MANUAL TRANSAXLE OIL





Oil grade:

API GL-4 or GL-5

Viscosity:

SAE 75W-90

Standard capacity:

2.5 liters (2.6 US qts, 2.2 Imp. qts)

7. INSPECT MANUAL TRANSAXLE OIL

(a) Inspect transaxle oil Testing and Inspection.

8. INSPECT FRONT WHEEL ALIGNMENT

(a) Inspect wheel alignment Front Wheel Alignment.

9. INSTALL ENGINE UNDER COVER LH

10. INSTALL ENGINE UNDER COVER RH

11. CHECK ABS SPEED SENSOR SIGNAL

(a) Check the speed sensor signal Installation.