Removal

SUSPENSION: FRONT STABILIZER BAR: REMOVAL

1. PLACE FRONT WHEEL FACING STRAIGHT AHEAD

2. REMOVE COLUMN HOLE COVER SILENCER SHEET Removal

3. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY Removal

4. DISCONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY

5. REMOVE FRONT WHEEL

6. REMOVE ENGINE UNDER COVER LH

7. REMOVE ENGINE UNDER COVER RH

8. REMOVE FRONT STABILIZER LINK ASSEMBLY LH





(a) Remove the 2 nuts and front stabilizer link LH.

HINT

Use a 6 mm hexagon wrench to hold the stud if the ball joint turns together with the nut.

9. REMOVE FRONT STABILIZER LINK ASSEMBLY RH

HINT

Use the same procedures described for the LH side.

10. DISCONNECT TIE ROD END SUB-ASSEMBLY LH Removal

11. DISCONNECT TIE ROD END SUB-ASSEMBLY RH Removal

12. DISCONNECT PRESSURE FEED TUBE ASSEMBLY Removal

13. DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY LH Removal

14. DISCONNECT FRONT SUSPENSION NO. 1 LOWER ARM SUB-ASSEMBLY RH

HINT

Use the same procedures described for the LH side.

15. REMOVE FRONT FLOOR PANEL BRACE Removal

16. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal

17. REMOVE HOOD SUB-ASSEMBLY

18. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

19. SUSPEND ENGINE ASSEMBLY Removal

20. REMOVE NO. 1 HOOK Removal

21. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY Removal

22. REMOVE FRONT NO. 1 STABILIZER BRACKET LH





(a) Remove the 2 bolts and front No. 1 stabilizer bracket LH from the suspension crossmember.

23. REMOVE FRONT NO. 1 STABILIZER BRACKET RH

HINT

Use the same procedures described for the LH side.

24. REMOVE FRONT NO. 1 STABILIZER BAR BUSH

(a) Remove the 2 No. 1 stabilizer bar bushes from the stabilizer bar.

25. REMOVE FRONT STABILIZER BAR