Removal

2AZ-FE COOLING: WATER PUMP: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. DRAIN ENGINE COOLANT Testing and Inspection

3. REMOVE FRONT FENDER APRON SEAL RH Removal

4. REMOVE ENGINE UNDER COVER RH

5. REMOVE FAN & GENERATOR V BELT Removal

6. REMOVE GENERATOR ASSEMBLY Removal

7. REMOVE WATER PUMP PULLEY

(a) Using SST, remove the 4 bolts and water pump pulley.

SST : 09960-10010

09962-01000

09963-00700

8. REMOVE WATER PUMP ASSEMBLY

(a) Remove the clamp of the crankshaft position sensor from the water pump.

(b) Disconnect the wire of the crankshaft position sensor from the clamp bracket.

(d) Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.

NOTICE:

Be careful not to damage the contact surface of the water pump and cylinder block.