Removal

EXTERIOR: FRONT BUMPER: REMOVAL

1. REMOVE FRONT FENDER LINER LH





(a) Remove the 3 screws.

(b) Partially remove the fender liner.

HINT

It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.

2. REMOVE FRONT FENDER LINER RH

HINT

Use the same procedures described for the LH side.

3. REMOVE FRONT BUMPER COVER





(a) Remove the 3 screws and 2 bolts.

(b) Using a clip remover, remove the clip labeled A, 2 clips labeled B, and 2 radiator protectors.

(c) Apply protective tape under the front fender.





(d) Using a screwdriver, detach the 6 claws labeled A and 2 claws labeled B, and remove the bumper cover.

HINT

Tape the screwdriver tip before use.

4. REMOVE FRONT BUMPER ENERGY ABSORBER

5. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY





(a) Remove the 6 nuts and reinforcement.

6. REMOVE FRONT BUMPER SIDE SUPPORT LH





(a) Remove the screw and bolt.

(b) Using a screwdriver, detach the 2 clips, and remove the side support.

HINT

Tape the screwdriver tip before use.

7. REMOVE FRONT BUMPER SIDE SUPPORT RH

HINT

Use the same procedures described for the LH side.